NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

Chapter 7 147
Commands
NSCONTROL AUTOLOGON
NSCONTROL AUTOLOGON
Enables or disables the autologon feature of certain NS 3000/iX
services.
Syntax
NSCONTROL AUTOLOGON=[{ON } [,ALL]]
[{OFF} [,service[,service]...]
Parameters
AUTOLOGON Enables or disables the automatic logon feature
available with the NFT, RFA, and RPM services. If
AUTOLOGON is not enabled, users must create a remote
session with the REMOTE HELLO command prior to
executing these services.
ON Enables autologon for an NS 3000/iX
service.
OFF Disables autologon for an NS 3000/iX
service.
ALL Alters the autologon state for the NFT,
RFA, and RPM services.
The services that allow autologon are:
NFT Changes autologon capability for the
NFT service.
RFA Changes autologon capability for the
RFA service.
RPM Changes autologon capability for the
RPM service.
Defaults: ON and ALL.
Discussion
NSCONTROL AUTOLOGON allows the user the ability to disable and
re-enable autologon for the NS 3000/iX services supporting this feature.
Autologon is enabled at NS 3000/iX startup. NSCONTROL AUTOLOGON
must be executed after the NSCONTROL START command. When the
NS 3000/iX services are stopped, the autologon option resets to the
default.
Disabling autologon may be important on those systems that use a
logon UDC to help enforce system security. With autologon enabled (the
default), a remote user can access local NFT, RFA and RPM services