NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

Chapter 7 141
Commands
NETCONTROL VERSION
NETCONTROL VERSION
Displays the version numbers for the network transport software
modules.
Syntax
NETCONTROL VERSION[=MOD]
Parameters
VERSION[=MOD] Displays the overall version of the network transport.
If qualified with the MOD keyword, displays the
version of each of the software modules of the network
transport and the overall version.
Discussion
The VERSION function of the NETCONTROL command allows you to
check the version numbers of the network transport modules to ensure
that they are compatible and up-to-date, or simply to confirm which
version is installed on your system. Unlike most other NETCONTROL
commands, transport does not need to be started to use this command.
Output from this command is the same as that produced by the
NMMAINT.PUB.SYS utility.
Example 1
Example 1 shows how to display the overall version number of the
network transport.
:NETCONTROL VERSION
NS3000/iX Transport 32098-20033 overall version = B.05.07
Example 2
To look at the version numbers of the individual modules, you specify
the MOD keyword. You will see a display like the one shown in
example 2. Note that the version numbers shown here are only
examples, and should not be used to check any actual installation.
:NETCONTROL VERSION=MOD
NS3000/iX Transport 32098-20033 module versions:
NM program file: NETCP.NET.SYS Version: B0507048
NL procedure: NET_CF_VERS Version: B0700013
NL procedure: NET_IPC_VERS Version: B0507029
NL procedure: NET_IPC_VERS2 Version: B0507012
NL procedure: NET_IPC_VERS3 Version: B0507012
NL procedure: NET_IPC_VERS4 Version: B0507011
NL procedure: SIVERS Version: B0507009