NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

Chapter 7 131
Commands
NETCONTROL STOP
When this command is entered with an X.25 NI name, the system
accesses the DTC/X.25 Network Access Subsystem to disable the X.25
address that is associated with this system. The DTC/X.25 Network
Access then no longer accepts connections for this system. There is no
impact on the connections established between any other systems and
the DTC/X.25 Network Access.
Example 1
Example 1 shows how NETCONTROL fits into the process of terminating
a node. In example 1, the node has an NS 3000/iX Link. The
NSCONTROL command prevents users or programs from accessing any
network services. (Refer to the NSCONTROL command page in this
section for a complete description of NSCONTROL.) NETCONTROL STOP
terminates all active entities of the network transport.
NOTE When multiple NETCONTROL or NSCONTROL commands are embedded in
UDC’s, commandfiles, or batch jobs, HP recommends the use of :PAUSE
commands between commands, to give each time to execute before
starting the next command.
:NSCONTROL STOP
:NSCONTROL ABORT
:NETCONTROL STOP
Example 2
Example 2 shows which network transport entities are affected by the
STOP function. As will be shown in examples 3 and 4, the keywords
included with the STOP function determine which entities are affected.
:NETCONTROL STOP
** NETXPORT ARP; Protocol stop
- Loc: 27; Class: 4; Parm= $00000000; PortID: $FFFFFE89
** NETXPORT Probe; Protocol stop
- Loc: 37; Class: 4; Parm= $00000000; PortID: $FFFFFE89
** NETXPORT IP; Protocol stop
- Loc: 105; Class: 4; Parm= $00000000; PortID: $FFFFFE89
** NETXPORT Control Process; Device Shutdown Warning
- Loc: 283; Class: 3; Parm= $04F502E6; PortID: $FFFFFE8A
** NETXPORT LAN NI; Network interface stop
- Loc: 29; Class: 4; Parm= $96430000; PortID: $FFFFFE81
** NETXPORT Map Tbl; Mapping Table Deleted
- Loc: 2; Class: 4; Parm= $D5208250; PortID: $D5208250
** NETXPORT IP Update; General protocol stop
- Loc: 19; Class: 4; Parm= $00000000; PortID: $FFFFFE88
** NETXPORT UDP; General protocol stop
- Loc: 25; Class: 4; Parm= $00000000; PortID: $FFFFDFF3
** NETXPORT Net Timers; Stopping
- Loc: 4040; Class: 4; Parm= $96430000; PortID: $FFFFFE81
** NETXPORT Control Process; Transport stop
- Loc: 51; Class: 4; Parm= $00000000; PortID: $FFFFDFF0