NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

Chapter 7 125
Commands
NETCONTROL STATUS
NETCONTROL STATUS
Displays status and configuration information for the transport entity
specified.
Syntax
NETCONTROL STATUS[=ALL] [;{NI=niName [;PROT=niProt]} ]
{NET=niname }
{GATE=gatehalfname }
{PROT=gProt }
Parameters
STATUS[=ALL] Specifies that any additional status information should
be displayed, if additional data is available beyond the
default.
NI=niname Specifies the name of a configured network interface to
display the status of. Enter any valid NI name from the
NMMGR Network Interface screen which is not a
gateway half. If the specified NI was not previously
configured and started, an “ENTITY NOT ACTIVE”
error will occur. If transport was not previously started,
a “TRANSPORT NOT ACTIVE” warning will occur.
Specifying NI=niname without the ;PROT= option
displays status for the network interface itself.
NET=niName Specifies the name of a configured network interface
which is not a gatehalf. Enter any valid NI name, as
configured with NMMGR.
GATE=gatehalfname
Specifies the name of a configured gateway half
network interface to display the status of. Enter any
valid gatehalf NI name from the NMMGR Network
Interface Configuration screen. If the specified gatehalf
NI was not previously configured and started, an
“ENTITY NOT ACTIVE” error will occur. If transport
was not previously started, a “TRANSPORT NOT
ACTIVE” warning will occur.
PROT=gProt
PROT=niProt Specifies that a protocol is the pertinent entity for each
specified function to act on. Enter the name of the
protocol, as follows:
gprot Specifies the name of one transport
general protocol to display the status
of. Valid inputs are TCP, UDP, PXP, or