NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

ManualsBrandsHP ManualsSoftwareMPE/iX 6.0 Operating System

121

122

123

124

125

126

127

128

129

130

Chapter 7 123

Commands

NETCONTROL START

example show creation of the general protocols. The START function

always creates the control process and the general protocols, if they do

not already exist, before acting on any of the other entities.

:NETCONTROL STATUS

TRANSPORT NOT ACTIVE. (NETXPORTWARN 0001)

ENCOUNTERED ONE OR MORE WARNINGS WHILE PROCESSING COMMAND. (CIWARN 4437)

:NETCONTROL START

** NETXPORT Control Process; Transport start

- Loc: 50; Class: 4; Parm= $0000002C; PIN: 44

** NETXPORT TCP; General protocol start

- Loc: 18501; Class: 4; Parm= $00865910; PortID: $FFFFDFF1

** NETXPORT UDP; General protocol start

- Loc: 19; Class: 4; Parm= $00000000; PortID: $FFFFDFF2

** NETXPORT IP Update; General protocol start

- Loc: 3; Class: 4; Parm= $00000000; PortID: $FFFFDFF4

** NETXPORT Net Timers; Starting

- Loc: 4440; Class: 4; Parm= $00000000; PortID: $FFFFDFED

The initiation events shown in this example are always executed for the

ﬁrst NETCONTROL START command, whether or not a network interface

is speciﬁed. However, once the general transport is initialized,

subsequent NETCONTROL START commands do not change the modules

of the general transport.

Example 3

Example 3 displays the error message that will appear if you issue a

NETCONTROL START command when the control process is already

initialized.

:NETCONTROL START

ALREADY STARTED. (NETXPORTERR 4045)

ENCOUNTERED ONE OR MORE ERRORS WHILE PROCESSING COMMAND. (CIERR 4436)

Example 4

In Example 4, the LAN NI, conﬁgured as LAN1, is started on the ﬁrst

NETCONTROL START command. Notice that the initiation events to

initialize the general protocols are immediately followed by the start of

the LAN NI with its associated protocols: IP, probe, and ARP. Compare

the displayed events to the deﬁned entities of Figure 7-1. The events

displayed show creation of the control process, the general protocols,

and the LAN NI entities.

:NETCONTROL START;NET=LAN1