NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

Chapter 7 113
Commands
NETCONTROL
NETCONTROL
Command used to initialize, terminate, and control the operation of the
network transport.
Syntax
{function}[;function]
NETCONTROL {entity }[;entity ]
Use
Available In Session? YES
In Job? YES
In Break? NO
Programmatically? YES
Breakable? NO
Capabilities? NM
Parameters
function Only one of each type of function is recommended on a
command line. Refer to function descriptions on the
following pages. The functions are:
ADDLINK TRACEOFF
DELLINK TRACEON
START UPDATE
STATUS VERSION
STOP
Only one of each type of function (START, TRACE, etc.)
is recommended on a command line. For example, the
command:
:NETCONTROL TRACEON=HDM;START;TRACEON=HD;NET=LAN1
is not recommended because TRACEON appears twice
and also appears with START.
entity One or more of the entities defined for NETCONTROL.
The keywords for these entities are shown in Figure
7-1.
NET Specifies a group entity that consists of a network
interface which is not a gateway half, and all the
protocol modules that are configured for that network
interface. Not all functions may be applied as a group;
see the individual command functions for details.