NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

Chapter 7 109
Commands
LINKCONTROL
LINKCONTROL
Activates or deactivates link level tracing on a specified
communications link. Provides link transmission error statistics and/or
configuration information.
Syntax
[A(ll) ]
[C(onfiguration)]
LINKCONTROL linkname {;STATUS=} [L(inkstate) ]
{, } [S(tat)istics)) ]
[D(iag(stats)) ]
[R(eset) ]
[,DATA ]
[ON] [,ALL ]
LINKCONTROL Linkname;TRACE=[OFF] [,PARTIAL][,buffsize][,tracefile]
[,FULL ]
Use
Available In Session? YES
In Job? YES
In Break? YES
Programmatically? YES
Breakable? YES
Capabilities? NM
Parameters
linkname The configured name of an active data communications
link. Only the link name specified in the LINK portion
of the configuration file (@LINK.linkname) is valid. The
character @ may be used to signify all active links.
(Partial wildcards, such as PSI@, are not allowed,
however.)
STATUS Requests status information about the link. May not be
used with the TRACE option. For all options, displays
the linkname, linktype, and additional information as
follows:
ALL Prints the information displayed by the
LINKSTATE, CONFIGURATION, and
STATISTICS parameters. These
parameters are described more fully
later in this section. Additional
information about the LINKCONTROL