NS3000/iX Operations and Maintenance Reference Manual (36922-90039)

Chapter 7 107
Commands
7 Commands
This section describes the NS 3000/iX network commands for the
NS 3000/iX services and associated links. The commands are listed in
alphabetical order and described in Table 7-1.
NOTE You must have NM capability to execute any of the following
commands.
Table 7-1 NS 3000/iX Network Commands
Command Description
LINKCONTROL Provides link information, or activates or deactivates link level
tracing.
LINKCONTROL STATUS Requests status information about the link.
LINKCONTROL TRACE Activates or deactivates link level tracing.
NETCONTROL Initiates, terminates, and controls the operation of the network
transport.
NETCONTROL ADDLINK Dynamically adds a configured network link to the active
network configuration.
NETCONTROL DELLINK Dynamically deletes a configured network link from the active
network configuration.
NETCONTROL START Initiates the network transport functional entities.
NETCONTROL STATUS Displays the status of the network transport functional entities.
NETCONTROL STOP Terminates the network transport functional entities.
Immediately terminates the Network Services. (You should
always terminate Network Services via NSCONTROL commands
first.)
NETCONTROL TRACE Enables or disables message tracing for a specified network
transport functional entity.
NETCONTROL UPDATE Dynamically updates selected network transport configuration
parameters for an active network interface.
NETCONTROL VERSION Displays the version of the software modules of the network
transport.
NSCONTROL Initiates, terminates and controls the operation of the Network
Services.
NSCONTROL ABORT Immediately terminates the Network Services.
NSCONTROL AUTOLOGON Enables or disables the autologon feature for the NFT, RFA, and
RPM remote network services.