NS3000/iX Error Messages Reference Manual (36923-90041)

62 Chapter5
NetIPC (SOCKERRS) Error Messages
ACTION: Verify that the proper bits are specified in the flags
parameter. Bit numbering is from left to right (0–31).
MESSAGE: INVALID OPTION IN THE opt RECORD.
8 CAUSE: An unsupported option was specified in the opt record, or a
nonprivileged user attempted to specify a privileged option.
ACTION: Check the options added to the opt record and remove or
modify the option. Verify that the opt record was initialized correctly
using INITOPT.
MESSAGE: PROTOCOL IS NOT ACTIVE.
9 CAUSE: A NETCONTROL has not been issued to activate the requested
protocol module.
ACTION: Notify your operator.
MESSAGE: PROTOCOL DOES NOT SUPPORT THE SPECIFIED
SOCKET TYPE.
10 CAUSE: The type of socket you are trying to create is not supported by
the protocol to be used.
ACTION: Use a different socket type or protocol.
MESSAGE: ERROR DETECTED WITH MAXIMUM MESSAGES
QUEUED OPTION.
12 CAUSE: Invalid option length specified or value of option is not positive.
ACTION: Correct option specification.
MESSAGE: UNABLE TO ALLOCATE AN ADDRESS.
13 CAUSE: No addresses were available for dynamic allocation.
ACTION: If unsuccessful the second time, see Appendix A, “Submitting
an SR,” of this manual.
MESSAGE: ADDRESS OPTION ERROR.
14 CAUSE: The address option in the opt record has an error in it (e.g.,
invalid length).
ACTION: Check the values being placed in the opt record.
MESSAGE: ATTEMPT TO EXCEED LIMIT OF SOCKETS PER
PROCESS.
15 CAUSE: User has already reached the limit of 64 sockets per process.
ACTION: Shut down any sockets which are not being used or have been
aborted.
MESSAGE: OUT OF PATH DESCRIPTORS OR PATH DESCRIPTOR
EXTENSIONS.
16 CAUSE: Transport’s Path Cache or Path Descriptor table is full.