NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 523
Logging Location Codes
TCP Logging Locations
MESSAGE: None
11903 CLAS0002 CAUSE: Connection was removed from TCP’s temporary IP list table.
See location 11901.
ACTION: PARM is source IP address of connection. Check configuration
for number of configured networks. If ok, then submit an SR.
MESSAGE: None
12001 CLAS0003 CAUSE: A connection received a packet with a bad checksum.
ACTION: Informative message. No action required. Bad checksums
usually indicate poor transmission quality.
MESSAGE: None
12002 CLAS0003 CAUSE: A connection received a packet with a bad checksum.
ACTION: Informative message. No action required. Bad checksums
usually indicate poor transmission quality.
MESSAGE: None
12003 CLAS0003 CAUSE: A connection received a packet with a bad checksum.
ACTION: Informative message. No action required. Bad checksums
usually indicate poor transmission quality.
MESSAGE: None
12004 CLAS0005 CAUSE: The TCP SIP tossed an inbound packet due to a bad checksum.
ACTION: Informative message. No action required. Bad checksums
usually indicate poor transmission quality.
MESSAGE: None
12101 CLAS0003 CAUSE: A TCP connection received a packet with precedence or
security options which do not match those of the connection. The
connection will abort.
ACTION: Remote protocol error indication. Use tracing or line analysis
to capture connection dialog. If precedence or security option of inbound
packet changes report an error against the remote implementation.
Otherwise, submit an SR.
MESSAGE: None
12102 CLAS0003 CAUSE: A TCP connection received a packet with precedence or
security options which do not match those of the connection. The
connection will abort.
ACTION: Remote protocol error indication. Use tracing or line analysis
to capture connection dialog. If precedence or security option of inbound
packet changes report an error against the remote implementation.
Otherwise, submit an SR.