NS3000/iX Error Messages Reference Manual (36923-90041)

486 Chapter19
Logging Location Codes
Remote Link Manager Logging Location Codes
ACTION: Check status of X.25 protocol on DTC. Possible causes include
bad/disconnected cable between DTC and switch/X.25 network, or the
switch/X.25 network is down. When problem is corrected, HP 3000 will
display additional logging messages.
MESSAGE: None
28 CLAS0002 CAUSE: Disconnect reply received from linkn contained bad status.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
29 CLAS0002 CAUSE: Subsystem specified a bad parameter in a connect or
disconnect request.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
30 CLAS0001 CAUSE: Control mismatch between DTC and HP 3000.
ACTION: See Appendix A, “Submitting an SR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP 3000.)
MESSAGE: None
31 CLAS0002 CAUSE: DTC sent bad packet to HP 3000.
ACTION: See Appendix A, “Submitting an SR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP 3000.)
MESSAGE: None
32 CLAS0002 CAUSE: Could not separate ('unbind') with link.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
33 CLAS0002 CAUSE: RLM attempted to send on a connection that was down.
ACTION: See Appendix A, “Submitting an SR,” of this manual. (Make
sure a dump is taken of both the DTC and the HP 3000.)
MESSAGE: None
34 CLAS0003 CAUSE: Close request received while resources were outstanding.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
35 CLAS0002 CAUSE: Received packet from link on unknown connection.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
36 CLAS0002 CAUSE: RLM could not free a buffer.