NS3000/iX Error Messages Reference Manual (36923-90041)

484 Chapter19
Logging Location Codes
Remote Link Manager Logging Location Codes
MESSAGE: None
10 CLAS0003 CAUSE: RLM could not release some internal resources (PARM =
Status returned by 'new_release_table_entry’).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
11 CLAS0001 CAUSE: RLM attempted to release a resource that had already been
released.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
12 CLAS0002 CAUSE: RLM received a connect reply message fromthe link that it did
not recognize.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
13 CLAS0003 CAUSE: The DTC is not responding to the HP 3000's connection
attempts. (i.e., The HP 3000 could not establish an AFCP link control
connection with the DTC.)
ACTION: Check state of DTC and LAN hardware. If no problem can be
found, see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
14 CLAS0001 CAUSE: RLM’s data structures are corrupted.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
15 CLAS0002 CAUSE: RLM could not release internal resources.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
16 CLAS0002 CAUSE: RLM received disconnect reply that did not match any
transaction in progress.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
17 CLAS0001 CAUSE: State mismatch within RLM’s data structures.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
18 CLAS0002 CAUSE: RLM received an inbound data packet over a connection that
is down.
ACTION: See Appendix A, “Submitting an SR,” of this manual.