NS3000/iX Error Messages Reference Manual (36923-90041)

398 Chapter19
Logging Location Codes
Dial ID Logging Location Codes
MESSAGE: None
33 CLAS0002 CAUSE: The sequence number of a reply packet sent from a remote
node does not match sequence number sent in the request packet sent
from the local node. Either the reply packet has been corrupted or the
remote node is not responding correctly to the Dial ID request packet
(PARM = sequence number received in the reply message)
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
34 CLAS0002 CAUSE: A reply packet was received but the Dial ID protocol was not in
the correct internal state to receive a reply (PARM = state of the Dial ID
protocol).
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
38 CLAS0002 CAUSE: A remote node is attempting connection and the network
number of its IP address does not match the network number of the
network interface over which the Dial ID protocol is active. An
acknowledgment rejecting the reply is sent to the remote node.
ACTION: Reconfigure either the remote node or local node so that the
network number of their IP addresses match. It is also possible that the
local node is calling the wrong phone number, therefore getting routed
to the wrong link and network interface.
MESSAGE: None
39 CLAS0002 CAUSE: The status field in a Dial ID reply packet was non-zero,
meaning the remote node has rejected the local node's request packet
(IE. rejected the connection attempt). (PARM = reason for rejection: (1)
The security string was invalid; (2) Format of the packet is bad; (3) The
IP addresses contained in the Path Report was invalid; (4) Rejected for
unknown reasons).
ACTION: Based upon the PARM value, verify that the configuration is
correct. It may be helpful to find the matching log message on the
remote node that prompted the rejection.
MESSAGE: None
40 CLAS0002 CAUSE: The status field of a Dial ID acknowledgment packet was
non-zero, meaning the remote node has rejected the local node's reply
packet (i.e., rejected the connection attempt). (PARM = reason for
rejection: (1) The security string was invalid; (2) Format of the packet is
bad; (3) The IP address contained in the Path Report was invalid; (4)
Rejected for unknown reasons).
ACTION: Based upon the PARM value, verify that the configuration is
correct. It may be helpful to find the matching log message on the
remote node that prompted the rejection.