NS3000/iX Error Messages Reference Manual (36923-90041)

388 Chapter19
Logging Location Codes
CX Logging Location Codes
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
10 CLAS0003 CAUSE: A port for communication between the CI and CT server
process could not be created.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
11 CLAS0002 CAUSE: A port DST entry could not be allocated for the port between
the CI and VT server.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
12 CLAS0003 CAUSE: The VT service could not be initiated.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
13 CLAS0003 CAUSE: A port message with an unexpected function code was received
from the VT server process.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
14 CLAS0002 CAUSE: The VT server process could not be created
ACTION: If the DSSERVER.NET.SYS program is missing, restore it from
the NS product tape. If there are no DSSERVERs running, then try to
run DSSERVER.NET.SYS to see if there are any loader errors. Wait for
the number of DSSERVERs to decrease, or increase the maximum
number of DSSERVERs by NSCONTROL SERVER = DSSERVER,,wmax.
(Only users with NM capability can use the NSCONTROL command.) See
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
15 CLAS0002 CAUSE: The local VT sever (VTL) has not been started via an
NSCONTROL command.
ACTION: Issue NSCONTROL START or NSCONTROL START=VTL to start
the local service, or wait until the service is started. (Only users with
NM capability, who also have ALLOW capability, can use the
NSCONTROL command.)
MESSAGE: None
16 CLAS0003 CAUSE: An NSCONTROL ABORT has been issued.
ACTION: Issue NSCONTROL START, or wait until the service is started.
(Only users with NM capability, who also have ALLOW capability, can
use the NSCONTROL command.)