NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 387
Logging Location Codes
CX Logging Location Codes
CX Logging Location Codes
MESSAGE: None
1 CLAS0003 CAUSE: The NS keyword table was not allocated during system startup
prior to an NS command execution.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
2 CLAS0003 CAUSE: The NS global data segment was not allocated during system
startup, or has been lost.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
3 CLAS0003 CAUSE: Bad format in the ASCAT.NET.SYS catalog.
ACTION: Check that the message sets of the ASCAT.NET.SYS catalog
are correct. Run the MAKECAT utility to prepare the message catalog
properly.
MESSAGE: None
4 CLAS0003 CAUSE: The NS keyword table is not large enough to contain all
keywords from the ASCAT.NET.SYS catalog.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
6 CLAS0002 CAUSE: The NS keyword table extra data segment could not be
allocated.because of insufficient memory or free DSTs.
ACTION: Contact your system manager to increase the number of
configured DSTs or obtain more memory.
MESSAGE: None
7 CLAS0003 CAUSE: The port used for communication between CI and the VT
server could not be added to the MPE port dictionary.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
8 CLAS0003 CAUSE: The VT service request could not be sent to the DSDAD process
port.
ACTION: See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: None
9 CLAS0003 CAUSE: The start VT port message could not be sent to the VT server
process.