NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 19 375
Logging Location Codes
Control Process Logging Location Codes
671 CLAS0002 CAUSE: During startup of the SNMP module, the configuration file was
unlocked. But afterwards, NETCP tried for up to 2 minutes to lock the
file again without success (PARM = status from NMConflockfile).The
2-minute timeout is not configurable.
ACTION: Network startup was incomplete. Stop the network. Use
:LISTF NMCONFIG.PUB.SYS,3 to verify the NMCONFIG file exists
and is not opened. If any users are currently running NMMGR, ask
them to exit. Then restart the network. If the problem persists, see
Appendix A, “Submitting an SR,” of this manual.
MESSAGE: INTERNAL ERROR; Device close
673 CLAS0002 CAUSE: While bringing down a device because of a serious
asynchronous error, powerfail, or a :NETCONTROL DELLINK command,
NETCP encountered an error when attempting to separate one of the
active protocols from the link driver (PARM = 32-bit status returned by
the call to ns_separate_from_driver).
ACTION: This in itself was not a fatal error, and other device stop
actions continued. However, either the DCLDM or the link driver may
have failed, which indicates a problem. No additional NETCP logging
or tracing information is available, though if problems continue,
DCLDM tracing and link tracing can be used to either follow the
separate request downward and locate the point where errors occur. If
the problem persists, see Appendix A, “Submitting an SR,” of this
manual.
MESSAGE: INTERNAL ERROR; Wrong autodial cable OUTBOUND;
occupied
674 CLAS0002 CAUSE: NETCP received an asynchronous event message from the
DCLDM indicating that its LAPB PSI’s autodial operation was not
completed, because the cable attached to the PSI card is not the proper
cable required for autodial operations (PARM = 16-bit internal ldev
number of the device). Older versions of Transport may print different
messages for this error, such as “OUTBOUND; occupied” or
“INTERNAL ERROR; Auto dial failure”, though the actual problem is
the cable.
ACTION: Install the correct cable and retry the operation. If the
problem persists then see Appendix A, “Submitting an SR,” of this
manual.
MESSAGE: Bad status
677 CLAS0002 CAUSE: While awaiting Path Verify replies from all general protocols in
response to requests sent previously, NETCP received a new message
on the control or reply subqueues of its port, which was not one of the
expected replies. NETCP then encountered an error while trying to
requeue that request for later processing, by resending it to itself
(PARM = 32-bit status returned by the call to send_msg).