NS3000/iX Error Messages Reference Manual (36923-90041)

328 Chapter19
Logging Location Codes
Control Process Logging Location Codes
Control Process Logging Location Codes
Control Process logging location codes are generated by the NETCP
process of Network Transport. For each of the logging explanations, any
or all of the following may be present:
PARM = Meaning of the parameter logged.
PORT = Transport port number of the Control Process.
NI = Network Interface Type against which the event was logged:
• FDDI = Fiber Distributed Data Interface LAN.
• GATEHALF = Gateway Half network over LAPB.
• LAN = IEEE 802.3 or Ethernet LAN.
• LOOP = Loopback network.
• ROUTER = Point to Point network over DCLDM and LAPB.
• SNA = NS over SNA/iX network (obsolete).
• TOKEN = Token Ring LAN.
• X.25 = Host-based or PC-based X.25 network.
Link = Link Type against which the event was logged:
• DCLDM = Data Communications Logical Device Manager for
LAPB.
• DTC = Distributed Terminal Controller configured for X.25.
• LAN = IEEE 802.3 or Ethernet LAN link.
• LAPB = PSI (Programmable Serial Interface) link.
• NS/SNA = NS over a specific SNA/iX LU (obsolete).
• TOKEN = Token Ring LAN link.
• FDDI = Fiber Distributed Data Interface LAN link.
• X.25 = X.25 over a DTC link.
MESSAGE: INTERNAL ERROR; Configuration file error
10 CLAS0002 CAUSE: While initially starting NETCP, or while starting NI specific
protocols on a LAN, GATEHALF, or ROUTER network, NETCP could
not get node name information from the NODENAME path in the
NMCONFIG file (PARM = 32-bit status returned by the call to
nmconfgetdata).