NS3000/iX Error Messages Reference Manual (36923-90041)

296 Chapter18
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
ACTION: Run the Sherlock diagnostics on the PSI and call your
Hewlett-Packard representative if a failure is detected.
MESSAGE: User invoked dump caused the driver to fail.
1032 CAUSE: A user manually instructed the driver to dump via diagnostic
utilities when the driver had not encountered previous errors.
ACTION: If the dump was taken as a snapshot of a problem, call your
Hewlett-Packard representative, and save the raw dump file to show to
the HP person.
MESSAGE: Dump-sequence failure.
1033 CAUSE: Possible causes for this problem are as follows:
1. The dump module is missing.
2. The driver encountered an error while attempting to produce a
dump. The driver has unlocked itself and reported to upper levels
the error which originally caused the dump attempt; these levels will
now destroy the driver. Any dump file produced is probably
incomplete.
ACTION: Possible actions for this problem are as follows:
1. Run NMMAINT.PUB.SYS to verify the dump module is present.
2. Write down the error information displayed on the console, submit
an SR, and call your Hewlett-Packard representative.
MESSAGE: An input message is being ignored.
1034 CAUSE: A message received by the driver was not recognized or
processing of it could not begin. It is also possible the source port is not
operating with the required capabilities. The message was logged and
dropped.
ACTION: The diagnostic system logfile should contain a partial image
of the ignored message. Write down the information from this logfile as
well as the error information displayed on the console, submit an SR,
and call your Hewlett-Packard representative.
MESSAGE: No TAB data structures available.
1035 CAUSE: TAB data structures are used whenever the driver attempts to
start new hardware activity. There is a limited number of these data
structures available. Unexpected use of incorrect port and subqueues
may have created excessive pending hardware activity. This problem
may also be reported if a buffer-manager buffer could not be obtained.
ACTION: Unsupported programs should not contact the driver through
incorrect subqueues. This problem should produce a dump; keep the
raw dump file along with the error information displayed on the
console, call your Hewlett-Packard representative, and submit an SR.