NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 18 293
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
MESSAGE: The PSI received a bad command from the driver.
1010 CAUSE: Internal error.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.
MESSAGE: PSI received a bad DMA command from the driver.
1011 CAUSE: Internal error.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.
MESSAGE: Unknown PSI module dependent hard error.
1012 CAUSE: Internal error.
ACTION: Write down the error information displayed on the console,
submit an SR, and call your Hewlett-Packard representative.
MESSAGE: The PSI detected a bad length count during download.
1013 CAUSE: Either the download file is corrupt, or there is an incorrect
version of the download file.
ACTION: Replace the download file from your latest system update
tape. You should also check the version of the download file with
NMMAINT and call your Hewlett-Packard representative if incorrect.
MESSAGE: PSI detected a bad checksum during download.
1014 CAUSE: Possible causes for this problem are as follows:
1. The download file is corrupt.
2. There is an incorrect version of the download file.
ACTION: Possible actions for this problem are as follows:
1. Replace the download file from your latest system update tape.
2. Check the version of the download file with NMMAINT and call your
Hewlett-Packard representative if incorrect.
MESSAGE: PSI received download blocks out of sequence.
1015 CAUSE: Possible causes for this problem are as follows:
1. The download file is corrupt.
2. There is an incorrect version of the download file.
ACTION: Possible actions for this problem are as follows:
1. Replace the download file from your latest system update tape.
2. Check the version of the download file with NMMAINT and call your
Hewlett-Packard representative if incorrect.