NS3000/iX Error Messages Reference Manual (36923-90041)

200 Chapter16
100VG-AnyLAN and 100Base-T Error Messages
SDI Driver Specific Status Values
Format the file on the system you took the trace or log on, or contact
your Hewlett-Packard Representative to check if VGFOS patches are
already available to correct this problem.
MESSAGE: Incomplete data was encountered.
245 ($F5) CAUSE: The trace or log formatter attempted to decode an entry, but on
inspection found that the entry did not contain at least the minimum
length of data required for this version of the data.
ACTION: The trace or log file may be corrupted, or you may be trying to
format a trace or log file taken on a different system that has newer
software than the system you are formatting on. The formatter will
attempt to print this entry in raw form. Format the file on the system
you took the trace or log on, or contact your Hewlett-Packard
Representative to check if VGFOS patches are already available to
correct this problem.
Logging Sublocation Codes
The following are the logging sublocation codes reported by the
100VG-AnyLAN and 100Base-T link drivers, including sublocation
code, log class, log message, and the appropriate cause of and action to
take for each.
For meanings of 32-bit status values generated by the driver, refer to
the sections on status values.
MESSAGE: Cannot freeze a memory area.
1020 CLAS0001 CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator was preparing to send configuration data to
the driver, but encountered an error while trying to freeze that data
into memory (“Cause”= 32-bit status from the call to freeze).
ACTION: The system may be low on available memory. Try closing any
unnecessary applications or sessions and retry the operation. The open
did not succeed. The module configurator cleaned up and returned an
error to the subsystem.
MESSAGE: Cannot send a port message.
1040 CLAS0001 CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator was preparing to send configuration data to
the driver, but encountered an error while trying to send the port
message (“Cause”= 32-bit status from the call to send_msg).
ACTION: There may be a system problem, or another subsystem has
already shut the driver down while this one was trying to start it. The
open did not succeed. The module configurator cleaned up and returned
an error to the subsystem.