NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 12 121
NETXPORTERR Error Messages
ACTION: Issue the NETCONTROL VERSION=MOD command for more
information. See Appendix A, “Submitting an SR,” of this manual.
MESSAGE: ! DEVICE NOT CONFIGURED.
4053 CAUSE: The link name specified with the ADDLINK or DELLINK
keyword in the NETCONTROL command line is not configured.
ACTION: Check the command for correctness. If it appears correct and
the link is configured correctly, see Appendix A, “Submitting an SR,” of
this manual.
MESSAGE: THE ENTITY IS NOT ACTIVE.
4054 CAUSE: Issued a NETCONTROL STATUS command on an inactive entity.
ACTION: None.
MESSAGE: INTERNAL ERROR ON STATUS, TRY AGAIN.
4055 CAUSE: NETCONTROL STATUS error.
ACTION: Wait and try again; if problem persists, see Appendix A,
“Submitting an SR,” of this manual.
MESSAGE: ! DEVICE ALREADY STARTED.
4056 CAUSE: The link name specified by the NETCONTROL ADDLINK
command has already been started.
ACTION: Check the command for correctness. If it appears correct, no
further action is required.
MESSAGE: ! DEVICE NOT STARTED.
4057 CAUSE: The link name specified by the NETCONTROL DELLINK
command is already shut down.
ACTION: Check the command for correctness. If it appears correct, no
further action is necessary.
MESSAGE: X25 NOT INSTALLED.
4058 CAUSE: An attempt was made to start an X25 network when X25 is not
installed on the system.
ACTION: Install X25. If X25 is properly installed then see “Appendix
A, “Submitting an SR,” of this manual.
MESSAGE: BAD UPDATE VALUE, EXPECTED INTERNET OR
MAPPING.
4059 CAUSE: Something other than the supported INTERNET or MAPPING
option follows the UPDATE= option in the NETCONTROL command line.
ACTION: Consult the NS 3000/iX Operations and Maintenance
Reference Manual for the correct syntax for the NETCONTROL command.
Once the syntax has been corrected, retry the command.