NS3000/iX Error Messages Reference Manual (36923-90041)

Chapter 12 115
NETXPORTERR Error Messages
12 NETXPORTERR Error Messages
NETXPORTERR messages are returned to $STDLIST when executing
the NETCONTROL command. The NETCONTROL command initiates,
terminates, and controls the operation of the Network Transport
subsystem of the links.
MESSAGE: TRANSPORT NOT ACTIVE.
0001 CAUSE: Issued NETCONTROL STATUS command on inactive transport.
ACTION: Issue NETCONTROL START.
MESSAGE: DIAG COMMAND NOT SUPPORTED. NETXPORT
RUNNING IN UNSUPPORTED MODE. RESTART NETXPORT TO
CLEAR CONDITION.
0011 CAUSE: The use of the NETCONTROL DIAG command invalidates
Hewlett-Packard support of Network Transport.
ACTION: Do not use the NETCONTROL DIAG command. This command
is reserved for Hewlett-Packard support personnel. Network Transport
must be shut down and restarted to clear the effects of this command.
MESSAGE: TRANSPORT STATISTICS UNAVAILABLE.
0020 CAUSE: A call to cache information used by the diagnostic tool has
failed, although the NETCONTROL START command has completed
successfully.
ACTION: Bring down the transport and retry the command. If the
problem persists, see Appendix A, “Submitting an SR,” of this manual.
MESSAGE: CONF= OPTION NOT SUPPORTED. NETXPORT RUNNING
IN UNSUPPORTED MODE. RESTART NETXPORT TO CLEAR
CONDITION.
0021 CAUSE: The use of the CONF= option in a NETCONTROL command
invalidates Hewlett-Packard support of the Network Transport.
ACTION: Shutdown the Network Transport and restart it without
using the CONF option.
MESSAGE: X.25 LEVEL 3 DOWN ON DTC FOR DEVICE linkname.
25 CAUSE: The DTC has lost or was unable to start level 2 and/or level 3
for the X.25 card specified in the NMCONFIG path LINK.linkname.
ACTION: No action required. When level 3 is established, the host will
be informed.
MESSAGE: TRACE FILE IS !.
2000 CAUSE: Informative message.