NetBase for MPE Reference Guide

Chapter 3
3-18
SHADOW - Check KSAM record counts
This parameter enables a further sync check on KSAM files to ensure that no records are missing
when writing new records to a KSAM file. This parameter should only be set to N if a master
system has a version of NetBase earlier than 9.5. Existing users have this option off by default. It
cannot be enabled until all master systems have been installed with the 9.5 NetBase shell. This
parameter takes effect when the START POST command is issued in NBCTRL.
Default = Y
SHADOW - Disable file autoresync
This parameter disables the auto synchronization of files that occurs when a file is purged or
erased. Normally, out of sync or discarding files will be put back into sync when the master copy is
erased or purged. This parameter takes effect when POST is started.
Default = N
SHADOW - Log Post Errors
When this parameter is set to Y, all synchronization errors will be logged to a file
PERRnnnn.DATA.NETBASE, where nnnn is the zero filled node number. This file is created by
NBPOST when the first error occurs. In order to facilitate this, build the file ahead of time using the
following syntax: BUILD PERR####.DATA.NETBASE;MSG. The specification for this file is in
PERRSPEC.DOC.NETBASE. This parameter takes effect when the START POST command is issued in
NBCTRL.
Default = N
SHADOW - Enable Quiet Period Flush
When this parameter is set to Y, it causes the shadow posting processes to keep track of the number
of TurboIMAGE dynamic transactions in process and to stop when the number of transactions in
process for all data bases is zero. This parameter takes effect when POST is started.
Default = N