NetBase for MPE Reference Guide

Appendix A
A-2
Before Installing NetBase
Before installing NetBase, determine which of the following scenarios describes your system, and
then take the action listed for that scenario.
• If you are updating from a NetBase 9.6 global installation, proceed to the “Updating From
NetBase 9.6 Global Install” section below.
• If you are updating from a version of NetBase that is prior to 9.6, or converting from an
account installation, turn to the “Installation Appendix” section at the end of this chapter
before performing the installation/update.
• If you are installing NetBase for the first time, proceed to Step 1 on the following page.
If you have any questions or if you are unsure about any of the steps, please contact Technical
Support at (714)-720-1434.
Updating From NetBase 9.6 Global Install
If you are updating from a previous version of NetBase 9.6 that is globally installed, proceed to the
following steps before you update.
_____ A. Stop all sessions and jobs except for NetBase.
_____ B. If shadowing, flush shadow transactions:
:RUN NBFLUSH.PUB.NETBASE,STOPWAIT;PARM=shadownode#
_____ C. Stop the NetBase background job:
:RUN NBCTRL.PUB.NETBASE;INFO=”STOP NETBASE”
_____ D. Disable the CM intercepts for NetBase:
:RUN NBVERS.PUB.NETBASE,DISABLE
_____ E. If the NMCMDUDC is set, delete it:
:SETCATALOG NMCMDUDC.PUB.NETBASE;SYSTEM;DELETE
_____ F. Back up the NetBase account to tape.