NBSpool for MPE Reference Guide

Chapter 7
7-16
Error Message Explanation/Action
SPOOL FILE HAS BEEN PURGED
The spool file you have specified has been
purged. Please verify, and re-enter.
*2
SPOOL FILE IS EMPTY
You may not view an empty spool file.
SPOOL FILE NOT ALTERED
The spool file you specified was not altered. The
values which were to be changed may have been
equal to the new values, so no modification was
necessary.
SPOOL FILE NOT PURGED
The spool file you specified was not purged, due
to an error. Additional information was provided.
SPOOL FILE NOT READY
This command requires that the spool file be in a
READY
state.
SPOOL FILE OPEN FAILED
See the
FSERR
message for more information.
SPOOL FILE SAVE FAILED
See the
FSERR
message for more information.
SPOOL FILE WRITE FAILED
See the
FSERR
message for more information.
Tape error ! encountered. Scanning for first
valid file...
The tape you loaded has errors. NBSpool is
searching for a valid file stored on the tape.
Tape mount failed.
The tape drive failed to load the tape. Attempt
again. If tape fails, use another tape.
THE “PREVIOUS SUBSET” DESIGNATOR
MUST BE USED BY ITSELF
You may not further define a subset when using
the previous subset option.
*2
THE DESTINATION MUST BE AN HP 3000
NODE
With this command syntax, the destination must
be an HP 3000 node.
*2
THE REMOTE lpr SERVER IS NOT
RESPONDING
The remote printer server is not responding.
Verify the JetDirect connection.
*2
THE SPECIFIED PROCESS IS NOT
RUNNING
The process you specified is not currently
running. Ask your system operator to start it.
THE SPECIFIED PROCESS NUMBER
APPEARS TO BE IN USE
Use a different number in your
XEQ
command or
stop the one currently using this
PROCNUM
.
The user NBSPOOL does not have rights to
access this queue
Check if
NBSPOOL
has the correct access to the
print queue, using
PCONSOLE
.