NBSpool for MPE Reference Guide

Troubleshooting NBSpool
7-15
Error Message Explanation/Action
RANGE NOT SPECIFIED
You did not specify a range.
*2
RECORD SIZE MUST NOT BE GREATER
THAN 1024 BYTES
You specified a record size that exceeds 1024
bytes. Please modify.
*2
REEL IS NOT A MEMBER OF THE
CURRENT SET
The tape you loaded does not belong to the store
set. Locate and load the proper tape.
REMOTE SESSION IS RUNNING A
PROGRAM
The remote session you have attempted to access
is busy running a program.
*2
RESULTING BLOCK SIZE IS GREATER
THAN 16384 BYTES
With the block factor specified, the resulting size
exceeds the maximum 16384 bytes. Modify the
block factor.
*2
RPM NETWORK SERVICE NOT STARTED
The RPM network service is down. Ask the
network administrator to start it with the
NSCONTROL
command.
*2
Server is not responding
The server crashed, or this indicates a protocol
error.
SPOOK TAPES CANNOT BE LABELED
TAPES
You may not attach an NBSpool label to a
SPOOK
tape.
*2
SPOOL BLKSZ ! INVALID
The block size specified for the spool file is
invalid. Re-enter your block size.
*2
SPOOL FILE ! DOES NOT EXIST
The spool file you have specified does not exist.
*1
SPOOL FILE ! IS NOT OPEN OR READY
The spool file you requested is not in a valid state
for the command you have specified.
*1
SPOOL FILE ! IS NOT READY
The spool file you requested is not in a valid state
for the command you have specified.
*1
SPOOL FILE ! IS UNAVAILABLE FOR
VIEWING
The spool file cannot be accessed. Try again
later.
*1
SPOOL FILE CLOSE FAILED
See the
FSERR
message for more information.
SPOOL FILE HAS BEEN PURGED
The spool file you specified has been purged
during the command’s execution. Informational
message only.