NBSpool for MPE Reference Guide

Troubleshooting NBSpool
7-5
Error Message Explanation/Action
CANNOT KEEP SPOOL FILE IN THE
“OPENED” STATE
The spoolfile you have attempted to
KEEP
is
currently
OPEN
. You may not
KEEP
any portion
of an
OPEN
spool file.
*2
CANNOT OPEN DISK FILE
See the
FSERR
message for more information.
CANNOT OPEN NETWARE QUEUE
The network is not responding to NBSpool.
NBSpool cannot perform the trans-network
function requested until the network responds.
CANNOT OPEN SPOOL FILE ! (FSerr !)
NBSpool cannot open the spool file you have
requested.
*1
CANNOT OPEN TTENV FILE
See the
FSERR
message for more information.
CANNOT OPEN TTYPE FILE
See the
FSERR
message for more information.
CANNOT SPECIFY A DATE IN THE FUTURE
The date must be either in the past or today’s
date.
*2
CANNOT SPECIFY BOTH “ENV=” AND
“NOENVR”
These two parameters are exclusive. You may not
apply both to the same command.
*2
CANNOT SPECIFY BOTH “PURGE” AND
“NEWPRI”
You cannot specify a new output priority for files
you are purging.
*2
CANNOT WRITE TO QUEUE
NBSpool cannot write to the network queue.
Verify
NBSPOOL
has access to print queue.
Check that
NBSPOOL
is a valid user with
password
“QUEST”
.
COMMAND IS LONGER THAN 254
CHARACTERS
An NBSpool command may not exceed
254
characters in length. Use
REDO
to edit your
command, and replace parameter names with
abbreviations where you can.
*2
COMMAND REQUIRES OP OR SM
CAPABILITY TO SPECIFY NETBASE NODE
You must have
OP
or
SM
capability to specify a
NetBase node. Ask your system manager for
help.
*2
COMMAND REQUIRES THE NETWORK
VERSION OF NBSpool
Without the Network version of NBSpool, you
may not execute this command.
*2
CONTINUATION LINE WAS NOT
CONTINUED
You specified a continue, yet a continuation line
did not follow.
*2