MPE/iX System Utilities Reference Manual (32650-90882)

88 Chapter4

BULDACCT

Operation

Migrating a speciﬁc account to a non-system volume set

To migrate a selected set of accounts to a non-system volume set use the VSACCT option of

BULDACCT. In this example the source computer and destination computer are the same.

The basic BULDACCT syntax is:

RUN BULDACCT;INFO="[acct_list]%VSACCT=user_vol_set"

In this example acct_list is the list of accounts to be migrated. The default account list is

@ or

all

accounts; user_vol_set must be a valid volume set name.

The following is a sample of the exact steps you would use to migrate an account called

GYPSY to a non-system volume set called target_vol_set.

1. Log on as manager.sys and store all the ﬁles in the selected account:

STORE @.@.GYPSY;;SHOW

2. Run BULDACCT with the VSACCT option to create job ﬁles BULDJOB1 and BULDJOB2:

RUN BULDACCT;INFO="GYPSY%VSACCT=target_vol_set"

3. Close system level UDC's residing in the GYPSY account (if any):

SETCATALOG udc_file;SYSTEM;DELETE

4. Remove the account from its existing location and make sure there is not a GYPSY

account on your target_vol_set:

PURGEACCT GYPSY

PURGEACCT GYPSY;ONVS=target_vol_set

5. Rebuild the account, group and user directory structure for target_vol_set:

STREAM BULDJOB1

6. Restore all GYPSY account ﬁles, making sure that the ﬁles whose creators have been

purged are also restored:

RESTORE ;@.@.@;SHOW;VOLSET=target_vol_set;CREATE=CREATOR

(You may wish to add ;OLDDATE to this command to preserve the

modify

access

and

create

dates.)

7. Reset all user and account level UDC's:

STREAM BULDJOB2

8. If a system level UDC was uncataloged in step 3 then set it again:

SETCATALOG udc_file;SYSTEM;APPEND

Migrating groups to a non-system volume set

If a given account already exists on a non-system volume set, you may use the VS option to

migrate groups of that account to that volume set. The basic BULDACCT syntax is:

RUN BULDACCT;INFO="[acct_list]%VS=user_vol_set"

The following is an example of the exact steps you would use to migrate the groups in the