MPE/iX System Utilities Reference Manual (32650-90882)

Chapter 20 183
SAINT
Operation
• type of boot
• size of machine
• size of code
ACTION You may try and use the PME or change the linker commands used to
build the NL that is the source of the PME. The linker commands that
affect the location of the pages are the limit option on the buildxl command
and the cleanxl command.
Internal ERROR. Attempt to read or write with index < 0
CAUSE SAINT has attempted to read or write a file using an invalid index. This is
an error in an input file or an internal error.
ACTION If an input file is indicated, check the input file for correct format and
contents; otherwise enter an SR and provide a copy of all the input files,
the SAINT program, and any output file.
An IMPORT STUB entry point was not found in the library
CAUSE One of the SOMs within the library (the NL loaded by SAINT loadsyslib
command) has made a call to a procedure external to itself, and no other
SOM in the library contains the procedure.
ACTION Find out which SOM the called procedure should reside in (that is, console
SOM, diagnostic SOM, and so on) and try relinking the library with
another version of the SOM.
An SXRT entry point symbol was not found in the library
CAUSE A procedure or intrinsic name in the DSXRT file (loaded by SAINT
loadsxrt command) has no corresponding code in the library (the NL
loaded by SAINT loadsyslib command).
ACTION First make sure that the correct version of the DSXRT file is being used for
the library. Once this has been verified, it is most likely that the warning
message can be ignored. Sometimes obsolete entries are left in the DSXRT
file but have no effect on system operation; however, if a warning message
exists
and the system is experiencing other problems (for example, will not
boot), further diagnosis may be necessary. Contact the factory.
ERROR on move data, file num = xx escape code = yyyyyyy
CAUSE When SAINT attempts to move data into a file and an error is detected by
the operating system a trap code is returned to SAINT. There will be
further error messages that will define the problem.
ACTION Determine the problem from the messages that follow.
Error - OUT OF DISK SPACE or internal pointer error
CAUSE The most common cause of this error is out of disk space. The other
possible cause is that an internal pointer has an invalid value in it.
ACTION First make sure that there is enough disk space on the volume set where
the file is being written. Next check the limits on the group and account
where the file is being written. The file name is in the