MPE/iX System Utilities Reference Manual (32650-90882)

Chapter 20 179
SAINT
Operation
6. Enter EXIT to exit the SAINT utility.
Each of the SAINT utility commands are described below and on the following pages.
BUILDPME
This command creates the permanent boot image from the internal data structures
(symbol tables, code arrays, and so on.) built by the SAINT utility in previous load
commands. These data structures keep track of the information designated by the load
commands previously invoked in this SAINT utility session.
Syntax
BUILDPME
bootimagename [,SXRT]
Parameters
bootimagename The name of the boot image file. This parameter is required.
SXRT A keyword designating whether or not a system cross-reference table
should be built.
Example
buildpme getit.gotit.good,sxrt
EXIT
This command terminates the SAINT utility, closes all files it is currently using, and
returns control to the process that invoked this session of the SAINT utility.
Syntax
EXIT
Parameters
None
Example
exit
FINDSYM
This command searches for the specified symbol name in the symbol table of the
designated boot image and displays pertinent information if the symbol is found. If you do
not specify a boot image file, SAINT uses the currently built boot image. If a boot image has
not yet been built and you do not specify a boot image file, SAINT returns an error.
Syntax
FINDSYM
symbolname [, filename ]