MPE/iX Intrinsics Reference Manual (32650-90875)

618 Chapter10
Command Definitions (QUIT-ZSIZE)
STARTSESS
status information.
Status Value Meaning
0
Successful
1411 Logon failed due to IDD overflow
1412 Logon failed due to JMAT overflow
1424 Missing or invalid user name in
logonstring
1426 Missing or invalid account name in logonstring
1431 Specified session user lacks interactive access (IA)
capability
1436 No such group in the account
1437 No such account in the system
1438 No such user in the account
1439 User lacks a home group, and a group was not specified in
logonstring
1444 Password required but not specified in logonstring
-1451 Ignored delimiter
-1452 Unknown parameter found in
logonstring ; ignored
-1458 Bad TERMTYPE specified in
logonstring ; default used
-1459 Invalid PRI specified in
logonstring ; default used
-1461 HIPRI then INPRI specified; INPRI used
-1462 INPRI too low; lowest valid INPRI used
-1463 INPRI too high; highest valid INPRI used
-1464 INPRI then HIPRI specified; HIPRI used
-1465 OUTCLASS specified; ignored
-1473 RESTART specified; ignored
-1479 Invalid time specified in
logonstring ; no time limit is
used
7000 The LDEV is out of range
7001 The LDEV must not be virtual
7002 The device specified by LDEV is not a terminal
7003 The LDEV is not free
7004 The LDEV is not job-accepting
7005 The LDEV is in diagnostic mode
7006 The LDEV terminal is down
7007 Down pending on LDEV