MPE/iX Intrinsics Reference Manual (32650-90875)

286 Chapter6
Command Definitions (FLUSHLOG-GETUSERMODE)
FWRITE
NOTE If octal codes %55 and %60 are selected with automatic page eject in effect (by
default or following an octal code of %102 or %402), the resulting skip is to a
location absolute to the page. A code of %60 is replaced by %303, and a code of
%55 is replaced by %304. Therefore, the resulting skip can be less than two or
three lines, respectively.
If automatic page eject is not in effect, a true double or triple space results,
%310 Skip to bottom of form
%311 User option (Hewlett-Packard 2613/17/18/19), skip to one line before bottom of
form (Hewlett-Packard 2608A/S)
%312 User option (Hewlett-Packard 2613/17/18/19), skip to one line before top of form
(Hewlett-Packard 2608A/S)
%313 User option (Hewlett-Packard 2613/17/18/19), skip to top of form
(Hewlett-Packard 2608A)
%314 Skip to next seventh line with automatic page eject
%315 Skip to next sixth line with automatic page eject
%316 Skip to next fifth line with automatic page eject
%317 Skip to next fourth line with automatic page eject
%310 -
%317
(Hewlett-Packard 2607)
%314 -
%317
(Hewlett-Packard 2613/17/18/19)
%320 No space, no return (next printing physically follows this)
%321-%377
(" ")
Single space (with or without automatic page eject)
%400 or
%100
Set postspace movement option (prints first, then spaces). If previous option was
prespace movement, the driver outputs a line with a skip to VFC Channel 3
(automatic page eject in effect) or a one line advance (equivalent to an octal code
of %201 without automatic page eject) to clear the buffer
%401 or
%101
Set prespace movement option (spaces first, then prints)
%402 or
%102
Set single-space option, with automatic page eject (60 lines per page)
%403 or
%103
Set single-space option, without automatic page eject (66 lines per page)
Table 6-2. Carriage Control Directives
Octal Code
(ASCII)
Description of Carriage Action