MPE/iX Error Messages Manual Vol 3 (32650-90880)

98 Chapter3
Error Messages Viii C 3
MPE/iX Error Management
in the string.
ACTION Check the string parameter and correct it.
200 MESSAGE WARNING ** The error management subsystem was
unable to open the System Catalog; error
messages cannot be obtained.
CAUSE When the user tried to access the System Catalog to
obtain error messages, an error occurred.
ACTION Check the System Catalog or Error messages.
201 MESSAGE WARNING ** Message set ! was not found in the
System Catalog.
CAUSE If the user is trying to access System Catalog with an
invalid subsystem number, this warning message is
issued.
ACTION Check the System Catalog and use the valid number.
202 MESSAGE WARNING ** Message set !, Error number ! was
not found in the System Catalog.
CAUSE When the user is trying to access the System Catalog with
invalid subsystem numbers and error number, this
warning message is issued.
ACTION Check the subsystem and error number before accessing
the System Catalog.
203 MESSAGE WARNING ** An unexpected error was
encountered while reading error messages from
the System Catalog.
CAUSE When the user tried to query the System Catalog with
subsystem numbers and message numbers, an internal
error occurred.
ACTION Check the subsystem numbers and message numbers.
204 MESSAGE The ERROR MANAGEMENT subsystem was unable to
initialize its semaphore.
CAUSE When the ERROR MANAGEMENT subsystem tried to
call the Control Block routine to initialize its semaphore,
an internal error occurred.
ACTION Check the internal error and contact the Control Block
routines owner.
205 MESSAGE WARNING ** One or more entries on the error
stack have been overwritten.
CAUSE If the user tried to dump the entire error stack and some
entries were overwritten, this warning message is issued
to warn the user of that fact.