MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 2 89
Error Messages Viii C 2
Measurement Interface
ACTION Determine why system power failure occurred.
-1 MESSAGE An I/O operation was aborted by user.
CAUSE Same as message content.
ACTION Determine why I/O was aborted.
Measurement Interface
(Subsystem 133)
5 MESSAGE The PID has not been created.
CAUSE The specific process no longer exists in the system. The
process has been specified by the Measurement Interface
(MI) user through the SUBCLASS_ARRAY parameter in
the procedure ENABLE_MEASUREMENTS.
ACTION Retry with the correct process ID.
10 MESSAGE The group PARM is greater than
MAX_GROUP_IN_CLASS for requested class.
CAUSE The user of procedures which require a group value
entered an index value for the group which is outside the
range for groups within a performance class.
ACTION Remove faulty value and try again.
15 MESSAGE Too many user or program names given in an
ENABLE_MEASUREMENT call; ENABLE_MEASUREMENTS
does continue, however.
CAUSE The user of the ENABLE_MEASUREMENT procedure
has requested more than 10 program names and/or 10
user names.
ACTION Reduce the number of names to 10 (10 programs and/or 10
user names) and try again.
25 MESSAGE The total subclasses were zero; condition not
acceptable.
CAUSE A negative or zero value for the parameter for
TOT_SUBCLASSER for ENABLE_MEASUREMENT
and/or DISABLE_MEASUREMENT procedures.
ACTION Correct the value and retry.
35 MESSAGE The measurement interface PID list is full.
CAUSE The user of ENABLE_MEASUREMENT has requested
more than 2700 processes to monitor.