MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 2 85
Error Messages Viii C 2
Low Level I/O
Representative.
-36 MESSAGE Unformatted media is being used.
CAUSE Same as message content.
ACTION Format media and try operation over.
-35 MESSAGE A parity, CRC, or other data type error was
detected.
CAUSE Possible hardware, media, or link failure.
ACTION Call your Hewlett-Packard Representative.
-34 MESSAGE The device was physically reset or the I/O
request was aborted by a reset request.
CAUSE Same as message content.
ACTION None.
-33 MESSAGE A
device powering on condition was detected.
CAUSE Same as message content.
ACTION Determine reason for device power failure.
-32 MESSAGE A write operation to a read-only device was
attempted.
CAUSE Same as message content.
ACTION Determine process that attempted operation. Call your
Hewlett-Packard Representative for assistance.
-31 MESSAGE Operator attention is required, for example,
printer is out of paper; tape needs next
reel.
CAUSE Same as message content.
ACTION Take action to correct condition. For example, put paper in
the printer.
-30 MESSAGE An unexpected end-of-file or resource
occurred; for example, disk transfer hit the
end of the volume or tape hit the end-of-tape
mark.
CAUSE Same as message content.
ACTION Call your Hewlett-Packard Representative.
-29 MESSAGE The device is not ready or is not responding.
CAUSE Same as message content.
ACTION Place device online.
-28 MESSAGE The I/O MANAGER must be locked for this
request and it is not.