MPE/iX Error Messages Manual Vol 3 (32650-90880)

82 Chapter2
Error Messages Viii C 2
Low Level I/O
ACTION None.
-64 MESSAGE The device does not support the requested
density.
CAUSE Same as message content.
ACTION Check file equation for incorrect density.
-63 MESSAGE The device parity error count exceeded the
maximum retry count.
CAUSE Same as message content.
ACTION Call your Hewlett-Packard Representative.
-62 MESSAGE The I/O completed successfully, and the last
available device status should now be read.
CAUSE Same as message content.
ACTION None.
-61 MESSAGE The download of the firmware failed.
CAUSE This could be caused by a number of problems. Most likely
the device being downloaded to is not present, or a
hardware failure has occurred.
ACTION Call your Hewlett-Packard Representative.
-60 MESSAGE The device could not be cleared/reset.
CAUSE This could be caused by a number of problems. Most likely
the device is not present, or a hardware failure occurred.
ACTION Call your Hewlett-Packard Representative.
-59 MESSAGE An incorrect hardware identification code was
returned from device.
CAUSE Device configured does not match device type.
ACTION Make sure device configured matches device type.
-58 MESSAGE A transmission error occurred; send the data
block again.
CAUSE Same as message content.
ACTION Call your Hewlett-Packard Representative to examine link
connection.
-57 MESSAGE An error has occurred.
CAUSE An I/O error has occurred. Device status is now available
that should further explain the problem.
ACTION None.
-56 MESSAGE An invalid internal software error occurred.
CAUSE The operating system software module had an internal