MPE/iX Error Messages Manual Vol 3 (32650-90880)

80 Chapter2
Error Messages Viii C 2
Low Level I/O
ACTION None.
8 MESSAGE The end of the media was detected.
CAUSE Same as message content.
ACTION None.
9 MESSAGE The I/O completed successfully with some
status available to be read.
CAUSE Same as message content.
ACTION None.
10 MESSAGE The read was terminated by an alternate end
of record (aeor).
CAUSE Same as message content.
ACTION None.
11 MESSAGE Tape density requested is unknown or
unsupported.
CAUSE Same as message content.
ACTION Verify that the tape density is appropriate for the device.
12 MESSAGE A save-set mark was detected.
CAUSE During an I/O operation involving the
HPC1501A/HPC1511A cassette tape drive, a save-set
mark (a type of index mark) was detected.
ACTION None.
13 MESSAGE Device adapter does not support asynchronous
event notification (aen).
CAUSE Device or device adaptor does not support asynchronous
event notification.
ACTION None.
14 MESSAGE Trying to remotely load a tape device that is
already loaded.
CAUSE Same as message.
ACTION None.
-75 MESSAGE Reservation conflict.
CAUSE A device (or element in the device) cannot be accessed due
to a reservation conflict.
ACTION Retry acquisition of the device later.
-74 MESSAGE Incorrect hardware type.
CAUSE The device or card is not of the proper type for the
configured software.''