MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 2 77
Error Messages Viii C 2
HPIO Channel Manager
DISCONNECT ORDER.
CAUSE Software error reported.
ACTION No action required.
227 MESSAGE The virtual quad chain specified an ILLEGAL
TERMINATING ORDER.
CAUSE Software error reported.
ACTION No action required.
228 MESSAGE The virtual quad chain specified an order
with the DMA continue bit set in an illegal
manner.
CAUSE Software error reported.
ACTION No action required.
229 MESSAGE The virtual quad chain specified an illegal
CLC (connect LOGCHANNEL) buffer.
CAUSE Software error reported.
ACTION No action required.
230 MESSAGE The virtual quad chain specified a buffer not
aligned to a 64-byte boundary.
CAUSE Software error reported.
ACTION No action required.
231 MESSAGE The virtual quad chain specified a DMA buffer
not frozen in memory.
CAUSE Software error reported.
ACTION No action required.
232 MESSAGE The channel hardware reported a loss of power
to the CIO backplane. As a result, all DMA
activity is terminated in an unknown state.
CAUSE Remote CIO power loss reported.
ACTION No action required.
233 MESSAGE The channel hardware is not ready for a
command. This error condition can never occur
on a functioning channel.
CAUSE Defective CIO channel adapter hardware.
ACTION Replace CIO channel adapter hardware.
236 MESSAGE Channel hardware configuration specifies an
invalid I/O module adapter type in the IODC
ROM.