MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 2 75
Error Messages Viii C 2
HPIO Channel Manager
ACTION No action required.
207 MESSAGE The WAIT sequence number in the request
information block for a DMA transaction is
illegal. This sequence number determines the
next step to start, resume, or abort a DMA
transaction.
CAUSE Channel Adapter Manager (CAM) data structure
corruption.
ACTION Take a system dump for analysis.
208 MESSAGE The SELFTEST sequence number in the request
information block for a SELFTEST request is
illegal. This sequence number determines the
next step to complete the device adapter
SELFTEST sequence.
CAUSE Channel Adapter Manager (CAM) data structure
corruption.
ACTION Take a system dump for analysis.
209 MESSAGE The CONTROL FUNCTION specified in a CIO
control request message is illegal. In
response, an error reply message is returned
to the requestor.
CAUSE Software error reported.
ACTION No action required.
211 MESSAGE A timer event message was received specifying
an illegal request number.
CAUSE Software error reported.
ACTION No action required.
213 MESSAGE The device adapter detected a LOGCHANNEL
error trap condition while processing an I/O
transaction. The transaction is forced to
terminate prematurely with accompanying
reported status information.
CAUSE Hardware error reported.
ACTION No action required.
214 MESSAGE An upper DMA requested a destructive
operation while it had other requests
pending.
CAUSE Software error reported.
ACTION No action required.
216 MESSAGE The device adapter aborted an I/O transaction