MPE/iX Error Messages Manual Vol 3 (32650-90880)

46 Chapter1
Error Messages
Distributed Terminal Subsystems
CAUSE A problem occurred while configuring the link manager.
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC WARNING P-L, Add Ldev to class failure (HLIO status
SSSSSSSS, ldev LLL).
CAUSE A class contains more than 255 devices, or a conflict in class names exists.
ACTION Run SYSGEN to verify the conflict.
MESSAGE DCC ERROR P-L, Configuration file close error SSSSSSSS.
CAUSE A problem occurred while closing the NMCONFIG.PUB.SYS file or the
NMCONFIX.PUB.SYS file.
ACTION Check that the files exist, and that adequate disk space is available for
them. If the files exist and the disk space is large enough, check for file
system or hardware problems.
MESSAGE WARNING: I/O config from last START NORECOVERY will be
used. (DCCWARN 100)
CAUSE A routine message; this indicates that a start recovery is being attempted.
ACTION No action is required.
MESSAGE DCC WARNING P-L, (Startup) cannot open NMCONFIG, status
SSSSSSSS.
CAUSE Cannot open the NMCONFIG.PUB.SYS file.
ACTION Check that the file exists and that it is not locked. If the file exists and is
not locked, check for file system or hardware problems.
MESSAGE DCC WARNING P-L, (Startup) cannot purge NMCONFIX, status
SSSSSSSS.
CAUSE The NMCONFIX.PUB.SYS file cannot be purged.
ACTION Check that the file exists. If the file exists, check for file system or
hardware problems.
MESSAGE DCC WARNING P-L, (Startup) cannot open NMCONFIX, status
SSSSSSSS.
CAUSE The NMCONFIX.PUB.SYS file exists but it cannot be opened.
ACTION Check that the file is not locked. If the file is not locked, check for file
system or hardware problems.
MESSAGE DCC WARNING P-L, (Startup) cannot create NMCONFIX, status
SSSSSSSS.
CAUSE A disk space problem, a file system problem, or a hardware problem exists.
ACTION Verify that enough disk space is available. If enough disk space is
available, verify that no the file system problems exist. Then, verify that
no hardware problems exist.
MESSAGE DCC WARNING P-L , (Startup) cannot copy record from