MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 1 45
Error Messages
Distributed Terminal Subsystems
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC ERROR P-L, (Ports status SSSSSSSS).
CAUSE A problem with the DCC or the port's subsystem occurred.
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC ERROR P-L, time out on reply msg, descriptors MMM.
CAUSE The DCC did not receive a reply message within the allotted time.
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC ERROR P-L, too many DTCs configured.
CAUSE The NMCONFIG.PUB.SYS file contains more than the supported number of
DTCs.
ACTION Remove excess DTCs from the NMCONFIG.PUB.SYS file and reboot.
MESSAGE DCC ERROR P-L, link name specified for the DTS does not
exist.
CAUSE The link name configured in NMMGR on the DTS DATACOMM &
TERMINAL CONTROLLER CONFIGURATION screen does not match
that on the LINK SELECTION screen.
ACTION Go the DTS DATACOMM & TERMINAL CONTROLLER
CONFIGURATION screen and enter the correct link name.
MESSAGE DCC ERROR P-L, link name specified for the DTS is not
available.
CAUSE A problem occurred with the link hardware; the LANIC might be in the
wrong slot or it might not be connected to the LAN.
ACTION Check the hardware configuration connections.
MESSAGE DCC ERROR P-L, too many links configured.
CAUSE More that eight links are configured.
ACTION Delete all unused links so that eight or less links are used.
MESSAGE DCC ERROR P-L, message received on wrong subqueue.
CAUSE A problem exists with the interprocess communication.
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC ERROR P-L, unrecognized message received.
CAUSE A problem exists with the interprocess communication.
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC ERROR P-L, internal DCC logic error.
CAUSE A problem internal to the DCC exists.
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC ERROR P-L, Link error status.