MPE/iX Error Messages Manual Vol 3 (32650-90880)

44 Chapter1
Error Messages
Distributed Terminal Subsystems
diagnostics.
• MMM and LLL are replaced by decimal values; used for detailed diagnostics.
• PATH is replaced by an NMCONF path or LLIO physical path.
MESSAGE DCC ERROR P-L, (LLIO status SSSSSSSS).
CAUSE A problem exists with the low-level I/O services.
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC ERROR P-L, (reply status SSSSSSSS, msg descriptors
MMM).
CAUSE A problem exists with interprocess communication.
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC ERROR P-L, Configuration file open error SSSSSSSS.
CAUSE The configuration file does not exist or it is locked.
ACTION Check to see if NMCONFIG.PUB.SYS exists. If it exists, verify that it is the
proper file type and that it is not locked.
MESSAGE DCC ERROR P-L, (NMCONF record error SSSSSSSS). NM Path:
NMMGRpath
CAUSE The DCC surrogate cannot read a record in NMCONFIG.PUB.SYS, or data
in the file was not validated or the data is corrupt.
ACTION Validate the NMCONFIG.PUB.SYS file and reboot. If necessary, replace the
file, validate the file, and reboot the system.
MESSAGE DCC ERROR P-L, configuration record data was invalid. NM
Path: NMMGRpath
CAUSE Data in the NMCONFIG.PUB.SYS file was not validated or the data is
corrupt.
ACTION Validate the NMCONFIG.PUB.SYS file and reboot the system.
MESSAGE DCC ERROR P-L, (HLIO status SSSSSSSS, ldev LLL).
CAUSE A problem exists with the high-level I/O services.
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC ERROR P-L, (Buffer manager status SSSSSSSS).
CAUSE A problem exists with the datacomm buffers.
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC ERROR P-L, (External procedure not found).
CAUSE A problem exists with DCC execution.
ACTION Contact your Hewlett-Packard support representative.
MESSAGE DCC ERROR P-L, (Memory management status SSSSSSSS).
CAUSE A problem with the system occurred; the DCC cannot obtain memory.