MPE/iX Error Messages Manual Vol 3 (32650-90880)

40 Chapter1
Error Messages
Distributed Terminal Subsystems
25 MESSAGE Path: NMMGRpath
Modem type not supported. (DTSERR=25)
CAUSE The modem type specified on the DTS TERMINAL
PROFILE screen is not 0, 1, or 2.
ACTION Modify the modem type specified on the DTS TERMINAL
PROFILE screen to specify the appropriate modem type.
Press Update Data.
27 MESSAGE Path: NMMGRpath
Must supply a physical path. (DTSERR=27)
CAUSE A physical path was not specified in the Physical Path
IEEE 802.3 Device Adapter field.
ACTION Go the IEEE 802.3 LINK CONFIGURATION screen and
enter the appropriate physical path. Press Update Data.
28 MESSAGE Path: NMMGRpath
Duplicate profile class name linkname used.
(DTSWARN=28)
CAUSE The same class name is used in a terminal profile or a
printer profile.
ACTION Remove the duplicate class name from the printer profile
or the terminal profile.
29 MESSAGE Path: NMMGRpath
Class name duplicated between printer and
terminal profiles. (DTSERR=29)
CAUSE The same class name is used for both a terminal profile
and a printer profile.
ACTION Remove the duplicate class name from the terminal profile
or the printer profile.
30 MESSAGE Path: NMMGRpath
Profile specified for non-nailed terminals is of
printer-type. (DTSERR=30)
CAUSE A printer profile is specified where only a terminal profile
is allowed.
ACTION Change the printer profile to be a terminal profile.
31 MESSAGE Path: NMMGRpath
Profile linkname specified for non-nailed PAD
terminals is of Printer-type. (DTSERR=31)
CAUSE A printer profile is specified where only a terminal profile
is allowed.