MPE/iX Error Messages Manual Vol 3 (32650-90880)

38 Chapter1

Error Messages

Distributed Terminal Subsystems

ACTION Go to the screen speciﬁed by the NMMGRpath and modify

the ldev number.

13 MESSAGE Path: NMMGRpath

Too many LDEVs are being used (must be ≤600).

(DTSERR=13)

CAUSE Too many logical device (ldev) numbers are being used.

ACTION Visit the screens that use ldevs and delete some ldev

numbers. The validation procedure allows a total of 600

ldevs.

15 MESSAGE Path: NMMGRpath

Defined LINK. linkname is not being used.

(DTSWARN15)

CAUSE The deﬁned linkname is not used by DTS or the network

interface.

ACTION This is a warning only. No action is required.

16 MESSAGE Path: NMMGRpath

Too many links are being used (max. number

allowed = 8). (DTSERR=16)

CAUSE The link speciﬁed in the NMMGRpath cannot be

processed. Too many links are already deﬁned.

ACTION Go back to the LINK SELECTION screen and delete the

link speciﬁed in the NMMGRpath. Delete all unused links

so that eight or less links are being used.

17 MESSAGE Path: NMMGRpath

Too many paths are being used (max. number

allowed = 8). (DTSERR=17)

CAUSE The link speciﬁed in the NMMGRpath cannot be

processed. Too many physical paths are already deﬁned.

ACTION Go back to the LINK SELECTION screen and delete the

link speciﬁed in the NMMGRpath. Delete all unused links

so that eight or less links are being used.

18 MESSAGE Path: NMMGRpath

Too many DTCs are being used (max. number allowed

= 24). (DTSERR=18)

CAUSE The DTC speciﬁed in the NMMGRpath cannot be

processed. Too many DTCs are already conﬁgured.

ACTION Go back to the DTC SELECTION screen and delete the

DTC speciﬁed in the NMMGRpath.

19 MESSAGE Path: NMMGRpath