MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 1 37

Error Messages

Distributed Terminal Subsystems

Data.

7 MESSAGE Path: NMMGRpath

DTS.PROFILE.linkname is not defined. (DTSERR=7)

CAUSE The linkname on the screen speciﬁed by the NMMGRpath

is not deﬁned; therefore, the proﬁle data record does not

exist.

ACTION Check that the proﬁle name exists on the DISTRIBUTED

TERMINAL SUBSYSTEM PROFILE SELECTION screen

and if it does, check that the data record for this proﬁle

was created. If the proﬁle data record was not created,

then update the linkname screen and press Update Data.

8 MESSAGE Path: NMMGRpath

The same station address or node name is being

used at DTS.DTC. SELECT.linkname. (DTSERR=8)

CAUSE The station address or node name used on the screen

speciﬁed by the NMMGRpath is also used on the screen

speciﬁed by the DTS.DTC.SELECT.linkname screen.

ACTION Go to the screen speciﬁed by the NMMGRpath or to the

screen speciﬁed by the linkname and modify the station

address or node name.

9 MESSAGE Path: NMMGRpath

The same LDEV #nnn is being used at

DTS.DTC.SELECT.linkname.CARD012. (DTSERR=9)

CAUSE The logical device (ldev) number is being used on the

screen speciﬁed by the NMMGRpath and on the

DTS.DTC.SELECT.linkname.CARD012 screen.

ACTION Go to one of the two screens and change the ldev number.

The ldev number must be unique for each port.

10 MESSAGE Path: NMMGRpath

The same LDEV #nnn is being used at

DTS.DTC.SELECT.linkname.CARD345. (DTSERR=10)

CAUSE The same logical device (ldev) number is being used on the

screen speciﬁed by the NMMGRpath and on the

DTS.DTC.SELECT.linkname.CARD345 screen.

ACTION Go to one of the two screens and change the ldev number.

The ldev number must be unique for each port.

12 MESSAGE Path: NMMGRpath

LDEV #nnn is too big (must be ≤999). (DTSERR=12)

CAUSE The logical device (ldev) number is bigger than the allowed

maximum ldev number.