MPE/iX Error Messages Manual Vol 3 (32650-90880)

36 Chapter1

Error Messages

Distributed Terminal Subsystems

is too small.

ACTION If the data record ﬁle has been compressed, it is impossible

to validate the ﬁle. Go to the UTILITY screen and use the

compression utility to make the ﬁle larger. Try to validate

the ﬁle. If it still fails, build the ﬁle from a copy of the

sample ﬁle NMSAMP1.PUB.SYS. If the problem persists

when verifying the new ﬁle, contact your Hewlett-Packard

support representative.

3 MESSAGE Path: NMMGRpath

The data record is empty (use Update Data

function key). (DTSERR=3)

CAUSE The data record was not created for the NMMGRpath.

ACTION Go back to the screen speciﬁed by the NMMGRpath,

update the screen, and press Update Data.

4 MESSAGE Path: NMMGRpath

The same physical path is being used at

LINK.linkname. (DTSERR=4)

CAUSE The physical path speciﬁed for this link is being used.

ACTION Go to the link screen speciﬁed by the NMMGRpath or go to

the link screen speciﬁed by the linkname, and modify the

physical path.

5 MESSAGE Path: NMMGRpath

The same station address is being used at

LINK.linkname. (DTSERR=5)

CAUSE The IEEE 802.3 station address is already used. Each

station address must be unique.

ACTION Go back to the screen speciﬁed by the NMMGRpath or go

to the screen speciﬁed by the linkname and modify the

station address.

6 MESSAGE Path: NMMGRpath

LINK.linkname is not defined. (DTSERR=6)

CAUSE The link name speciﬁed on the DTS DATACOMM &

TERMINAL CONTROLLER CONFIGURATION screen is

not deﬁned; therefore, the link data record was not

created.

ACTION Verify the link name on the DTS DATACOMM &

TERMINAL CONTROLLER CONFIGURATION screen.

Check that the link name exists on the LINK

SELECTION screen and if it does, check that the link data

record was created. If the link data record does not exist,

update the LINK SELECTION screen and press Update