MPE/iX Error Messages Manual Vol 3 (32650-90880)
Chapter 1 35
Error Messages
Distributed Terminal Subsystems
Distributed Terminal Subsystems
(DTSERR)
This chapter contains validation and Datacomm Configurator (DCC) error messages.
Validation errors indicate problems with the network management configuration file. They
are detected during network management configuration file validation. DCC errors
indicate problems with the link or the DTS manager. They are detected when the host is
rebooted.
Validation Error Messages
The network management configuration file must be validated before it can be processed
by SYSGEN. The validation procedure is invoked in NMMGR by requesting it on the
VALIDATE CONFIGURATION FILE screen. Error messages will be displayed on the
system console. Additionally, error messages can be directed to a printer. The DTS
validation procedure starts by displaying the following on the system console:
197 - Validation of DTS/LINK started. -
Errors are then listed to the console. When the validation procedure is complete, it will
print the following on the system console:
nnn Encountered Errors
NOTE
After successful validation, run SYSGEN to cross-validate the DTS
configuration with the System configuration.
197 - Validation of DTS/LINK finished. -
where nnn is the total number of errors found during validation. Following is
a numerical list of validation error messages and actions for each.
1 MESSAGE Path: NMMGRpath.
A read error encountered while reading the data
record (bad file). (DTSERR=1)
CAUSE Either a hardware problem occurred or the data record is
too long.
ACTION Try to print the network management configuration file.
Rebuild the file from a copy of the sample file
NMSAMP1.PUB.SYS. If the problem persists, contact your
Hewlett-Packard support representative.
2 MESSAGE Path: NMMGRpath.
A write error encountered while updating the
data record (bad file). (DTSERR=2)
CAUSE Either a hardware problem occurred or the data record file