MPE/iX Error Messages Manual Vol 3 (32650-90880)

312 Chapter7
TurboIMAGE/XL V iii C 5
Workstation Configuration
none follows. This is most likely caused by two commas in a row, or a
comma at the end of a line without the ampersand.
ACTION Remove the extra comma, or insert the appropriate character.
MESSAGE Modification of data is not allowed.
CAUSE
Enter was pressed after choosing the View file option. In View mode,
modification of data is not allowed.
ACTION Use only the soft keys.
MESSAGE MPE/V termtype file; use Form X to convert to MPE XL
format.
CAUSE The terminal-type file name entered in the Terminal Type File Name field
is in MPE V format.
ACTION Convert the MPE V termtype file to MPE/iX format.
MESSAGE Response must be in the range from nn to nn.
CAUSE The field contains a value that is not within the range specified.
ACTION Enter a value within the correct range.
MESSAGE Response must be None, Line, Page, or Both.
CAUSE The field requires N, L, P, or B as a valid response, but a different value
was input.
ACTION Change the value to N, L, P, or B.
MESSAGE Response must be ON or OFF.
CAUSE The only valid entries for this field are ON and OFF, but some other value
was entered.
ACTION Change the value to either ON or OFF.
MESSAGE Response must be YES or NO.
CAUSE The field requires either a Y or an N as a valid response, but a different
value was input.
ACTION Change the value to a Y or N.
MESSAGE Termtype file is already in MPE XL format.
CAUSE Because the terminal-type file is already in MPE/iX format, there is no
reason to convert it to MPE/iX format.
ACTION An action is not required.
MESSAGE The field can only contain digits.
CAUSE The field is designed to accept only positive integers. The value entered
contains characters other than digits.
ACTION Enter a positive integer in the field.
MESSAGE The required field is empty.