MPE/iX Error Messages Manual Vol 3 (32650-90880)

304 Chapter7
TurboIMAGE/XL V iii C 5
Utility Error Messages
CAUSE User's label was not readable. Problem may be in
hardware.
ACTION Notify the system manager of the error.
-64 MESSAGE SET NUMBERS ARE OUT OF SEQUENCE.
TURBOIMAGE FAILED AT
xxxxx
CAUSE The next set number on the backup volume was not what
DBLOAD expected. Status element 0 has the expected set
number; status element 1 has the next set number on the
backup volume.
ACTION The schema may have been changed since the last
DBUNLOAD and this DBLOAD. Add any new set the the
end of the schema.
-66 MESSAGE BLOCK NUMBERS ARE OUT OF SEQUENCE.
TURBOIMAGE FAILED AT
xxxxx .
CAUSE The next block on the backup volume was not what
DBLOAD expected. Status elements 0,1 have the expected
block number; elements 2,3 have the actual next block
number; element 4 has the set number.
ACTION An error for a known value that was written to tape with
FWRITE was found. There may be a defect in the tape or
the tape drive.
-70 MESSAGE ENTRY NUMBERS ARE OUT OF SEQUENCE.
TURBOIMAGE FAILED AT
xxxxx
CAUSE The next block on the backup volume was not what
DBLOAD expected. Status elements 0,1 have the expected
block number; elements 2,3 have the actual next block
number; element 4 has the set number.
ACTION An error for a known value that was written to tape with
FWRITE was found. There may be a defect in the tape or
the tape drive.
-74 MESSAGE THE RECORD JUST READ IS UNRECOGNIZABLE
TURBOIMAGE FAILED AT
xxxxx
CAUSE The record just read from the backup volume was not what
DBLOAD expected. The record could be an EOF, EOT, etc.
The status element 0 has one of the following codes for the
record expected:
0 –
tape head
1 –
data file head