MPE/iX Error Messages Manual Vol 3 (32650-90880)

Chapter 7 303
TurboIMAGE/XL V iii C 5
Utility Error Messages
transaction recovery mechanism. The switch failed. nn is the switch to NM
error number returned.
ACTION Notify HP Support Representative.
MESSAGE UNABLE TO CONTINUE
CAUSE DBUTIL program (operating in PURGE mode) cannot continue execution
due to exceptional error in file system. This information is followed by
MPE/iX file information display.
ACTION Save the file information. Consult with system manager and HP Support
Representative.
MESSAGE UNABLE TO OBTAIN FILE LABEL INFORMATION FOR FILE
x
CAUSE MPE/iX internal procedure failed. DBUTIL cannot obtain information for
the specified file.
ACTION Contact your system manager.
MESSAGE UNEXPECTED ROOT FILE STATE
CAUSE The MOVE process was unable to reset the database flag. The database
may be in an inconsistent state.
ACTION Contact your system manager.
MESSAGE WARNING: USER LOG FILE IS NOT IN THE SAME VOLUME SET AS
THE DATABASE
CAUSE MPE/iX transaction recovery requires that the MPE/iX user log file must
reside on the same volume set as the database.
ACTION Build the MPE/iX user log file in the same volume set as the database.
NOTE: Because all files in a group are in the same volume set, the MPE/iX
command LISTGROUP indicates the volume set where the database
resides.
Extended Utility Program Unconditional Messages
A set of messages may be returned when an unusual condition causes TurboIMAGE/XL to
fail while a TurboIMAGE/XL utility is executing. In each of the following messages, the
value xxxxx is the location where TurboIMAGE/XL failed.
Error messages 401 through 414 are all TurboIMAGE/XL utility failures caused by failure
of the TurboIMAGE/XL intrinsic specified in the message.
-3 MESSAGE TURBOIMAGE FAILURE
(FREADDIR FAILURE ON ROOT FILE AT
xxxxx )
CAUSE Root file was not readable. Problem may be in hardware.
ACTION Notify the system manager of the error.
-4 MESSAGE TURBOIMAGE FAILURE
(FREADLABEL FAILURE ON ROOT FILE AT
xxxxx )